MOREC
MOREC EV Charger Holder for Type 1 SAE J1772 Connector Mounts
- Fits all SAE J1772 type connectors and mounts
- This durable accessory is used to keep insects and dirt out of your EVSE
- Keep your garage organized by placing the charger in the dock instead of resting it on a shelf
- SAE J1772 Electric Vehicle charger holster stores charger plugs safely out of the way, protecting them from damage
- If there's any issue with the product, please contact our service team. Satisfactory solutions are promised.
Full-link temperature monitoring
The charger is equipped with 8 protection functions, the most prominent of which is the temperature detection function. MOREC charger can monitor the temperature of the entire link between the power plug, cable, case and car end plug, and to cut off the current within 0.2s if the temperature rises above the set value at any point. Once the temperature has dropped, the unit will reapply power.
Superb adaptability
MOREC has been specialising in EV charging for over 10 years and has accumulated a large number of charging cases and industry experience.
MOREC's chargers comply with 99% of SAE J1772 electric vehicle standards and can be used in a variety of different usage scenarios to provide you with the best experience.
LCD DISPLAY
Charging Current
Display of real output current
Charging Voltage
Display of real time output voltage
Power Consumption
The power consumption of this charging process
Charging Time
Duration of charge
Temperature
Working temperature of the charger / device
Rated Current
Maximum charger current
Product Specifications
Service Life:>10000 times
Withstand Voltage: 2000V
Insulation Resistance: > 1000M
QInlet cable spec: 3* 6mm
Terminal Temperature rise: <50K
Shell Material: ABS
Contact Impedance: 0.5m
MaxCable diameter: 15 (mm) / 0.59 (in)
Working Temperature: -30°C ~+ 55°C
Contact Pin: Copper alloy, silver or nickel plating
Sealing gasket: rubber or silion rubber
Vibration Resistance: Meet JDQ 53.3 requirements
Shell Material: Thermo Plastic ( Insulator inflammability UL94 VO)
FAQ
Shipping
Sorry，the unit of temperature cannot be adjusted.
Yes, a neutral is needed,the neutral and two phase connections are featured in the L14-50 plug. With ground too.
Yes, it will. You will need a 240 volt service installed (same as an electric dryer) to support the Level 2 charging capacity. Any competent electrician can install this service.
You will receive a copy when you receive your package, if it is missing please contact us
Not directly. The charger uses the common NEMA 14-50 outlet, while most 30 amp dryer expect a NEMA 14-30 outlet.A conversion NEMA 14-30P to NEMA 14-50R adapter needs to be inserted in between for you.
If you purchase a charger with a switching feature, you will be able to set the current
Yes, but you need to use the J1772 to Tesla adapter that comes with every Tesla.
Yes,It depends on the highest current your battery can withstand. Our charger automatically adjusts the current based on your vehicle's batter